Listed below are the panniers I am becoming – reproduction WD panniers from eBay, most likely made in India. They’re somewhat good:
The frames are powder coated metal and fold up and down, similar to the originals, although the pannier luggage themselves are similar – initially they have been handed to the extent that one was supplied with a buckle to obtain that central strap on the again, so you could possibly sling them over the bags service like a pair of recent throw-over panniers:
I’ve obtained this set of brackets from Draganfly – very properly made too, although I needed to clear the threads of scale, open the holes to clear 1/4″ CEI and replicate the slots proven within the Ariel components checklist:
Place ‘B; reveals the rear mounting, with the tip of the mudguard bracket simply seen. There is a 5/16″ CEI bolt at ‘B’, which you employ once you need to raise the tail of the mudguard or take away the pannier body:
The opposite finish reveals the pannier body and the entrance bracket above the axle nut ‘E’. It is retained behind the mudguard keep bolt:
Extra later, when I’ve completed the bags service!